The Canadian healthcare system is not yet prepared to access and leverage IoT (Internet of Things) data to support clinical decision making outside of hospital settings (Nguyen et al., 2017). With advances in low-cost IoT technology, it is now possible to meaningfully incorporate a variety of sensors into our homes and communities, leading to the […]

Gallium nitride (GaN) high-electron-mobility transistors (HEMTs) are good candidates to replace the traditional silicon-based transistors. Although these devices show superior performances compared to Si and SiC-based devices, they suffer from some reliability issues. The aim of this research project is to improve the performance of the GaN HEMTs and enhance their reliability by performing a […]

Identifying an optimal routing, that ensures a delivery passage between suppliers and vendors, with a minimum cost while respecting the various constraints (including shortest delivery, availability of fleets and routes, traffic, etc.), could be a challenging task. This is mainly due to the need to solve a combinatorial optimization problem with discrete choices of pathways […]

Aircraft flight simulators are important to airworthiness standards and thus safety. The simulators are used in pilot training, as well assisting in the design of flight vehicles. Flight simulators need physical models that reproduce, in the computer, the real devices such as engines, pilot human response, cockpit, etc. In particular, it also needs an aerodynamic […]

Due to the length and intrinsic flexibility of cable-supported bridges, wind causes serious challenges to designers of such structures. To ensure the safety of these bridges, it is common practice to test scale models of bridges in the wind tunnel. As bridges are getting longer, simplifications used for typical wind tunnel test become questionable. Therefore, […]

Median sternotomy is the standard approach in heart surgery. Over 1.5M operations are performed worldwide annually; 45K in Canada. Wires are used post-operatively to close the sterna, leading to instability, micro-motion and pain. Alternative techniques lack effectiveness or are cost prohibitive. Glass polyalkenoate cements (GPCs) are used in restorative dentistry, orthodontics and ear, nose and […]

Whisky is made by a process of fermentation, distillation, and maturation. The last step is by far the most time-consuming part of this process. In order for maturation to occur, the distilled spirit must sit in a wooden barrel for years, during which the spirit takes on the familiar colour and taste of whisky. This […]

The bank swallow is a species of insectivorous songbird considered to be threatened in Canada and has been prioritized for conservation action. All swallow species in Canada are migratory, and in their annual cycle, the post-breeding to first migration period is considered to be a difficult and dangerous time for juvenile birds. We propose to […]

The proposed research project is to design a microfluidic contact lens that will be used to track the fluctuations in intraocular pressure. Intraocular pressure is the primary factor to monitor the progression of glaucoma, which is a chronic disease that leads to permanent vision loss and currently has no cure, making early and frequent testing […]

The applicability of reinforcing shear walls with FRP bars in resisting wind loads and small to medium magnitude earthquakes has was validated through several investigations. The most significant advantage of the FRP-RC is the considerable elastic deformation capacity and the self-centering ability of up to near failure. However, Current limitations of FRP design codes concerning […]

Osteoarthritis (OA) is a common disease in middle-aged and older Canadians attending primary care practitioners. As the Canadian population ages and with increasing obesity, OA will become an increasing burden for individuals and the health care system. Given the potential of Electronic Medical Record (EMR) data for surveillance of the population that is at high […]

The “Assessing forest harvesting impacts on furbearer habitat at the scale of Indigenous traplines – A case study in Indigenous consultation and forest conservation” project is planned to enhance the understanding of Indigenous rights holders concerning forest management activities that impact the distribution of forest types and ages upon which the forest dwelling wildlife that […]