A new type of ecologic ultra-High-performance glass concrete (UHPGC) has been developed at University of Sherbrooke through the use of waste glass materials of different particle-size distributions derived from glass culets. The developed UHPGC proved to give several technological, economical, and environmental advantages compared to the conventional ultra-high-performance concrete (UHPC). Producing UHPGC mixtures fitting the […]

Corrosion of internal reinforcement of concrete bridges represents a significant issue. Due to a presence of deicing salts, cycles of freezing and thawing, sustained and repetitive loads, the concrete loses its ability to protect the internal reinforcement. Unprotected reinforcement starts to corrode sooner than anticipated and, therefore, reduces the bridge service life. To avoid shortening […]

Ultra-High Performance Fiber Reinforced Concrete (UHP-FRC) material, can be considered a promising way to innovate in the management of Low and intermediate level radioactive waste (LILW) storing industry. UHP-FRC exhibits exceptional mechanical, serviceability, and durability characteristics in comparison to its traditional concrete counterparts. The current proposal focuses on the use of UHP-FRC in a new […]

Protection systems perform vital function in power distribution systems to ensure safety of public and equipment during network faults, and usually designed assuming a single power source supply. Distributed Energy Resources (DERs) are fast becoming an integral part of most Electric Power Systems around the world. Improvement in reliability, efficiency, power quality, and reduction in […]

Alberta’s oil sands are one of the world’s largest known hydrocarbon deposits. Current commercial recovery methods such as Steam Assisted Gravity Drainage (SAGD) require large amounts of steam. This in turn means that large amounts of natural gas are burned to produce steam resulting in significant greenhouse gas emissions. Solvent injection is one initiative that […]

AlbCurrent commercial recovery method of Alberta’s oil sands is Steam Assisted Gravity Drainage (SAGD) which requires large amounts of steam. This means that large amounts of natural gas are burned to produce steam resulting in significant greenhouse gas emissions. Solvent injection is one initiative gaining interest to overcome the aforementioned limitations. Certain reservoir conditions, including […]

Onshore and offshore pipe systems may be subject to loading events that result in mechanical response exceeding the material strength. There are technical and economic incentives for developing non-conventional, higher strength materials for use in long distance, large diameter and high pressure transmission pipeline systems. There exists uncertainty on the key factors influencing the mechanical […]

Organic light emitting diodes, or ‘OLEDs’ have become a common technology in everyday displays such as mobile phones, laptops, and televisions. These types of devices rely on an OLED structure that uses ‘bottom-emission’, meaning that the top of the device consists of a non-transparent backplane, and the light and colours generated in the device are […]

The candidate will utilize his knowledge and experience in transmission line modelling to implement test cases required by BC Hydro to validate the results of measured induced voltages between the transmission lines and gas pipelines. The simulations will be performed using well-known computer packages available at power laboratories of the University of British Columbia as […]

In this project, a series of highly efficient and highly selective multifunctional Guerbet catalysts are developed and will be investigated for the condensation of low alcohols to high alcohols in a continuous-flow reactor. Low energy density bioethanol and methanol will be upgraded to n-butanol and iso-butanol with high energy content comparable to gasoline with high […]

Histopathology is the study and examination of tissue slides under magnification and is the definitive diagnosis for many diseases including cancer. With the advent of whole-slide scanners and image management software systems, computational pathology tools can be created to measure disease in an efficient and objective manner. This is in contrast to the labourious and […]

La fatigue des matériaux est un phénomène d’endommagement. Ce dernier a donc un impact négatif sur les équipements qui sont sollicités de telle sorte dont les turbines hydrauliques servant à produire l’hydro-électricité. Il devient donc nécessaire d’enrichir les connaissances dans ce domaine pour diminuer l’importance de cette dégradation sur des composants aussi critiques que les […]