Étude du comportement hydrodynamique, et diphasique d’un classificateur à lit fluidisé – Phase 2

Le projet a pour but d’analyser le comportement d’un fluide diphasique, mélange de bauxite et d’eau, dans un classificateur à fond plat soumis à l’effet de plusieurs paramètres. Une étude expérimentale utilisant un classificateur à échelle réduite permet d’effectuer les mesures de fraction solide (pourcentage de solide dans l’échantillon) aux sorties du classificateur, ainsi que […]

Read More
Using RTLS and Computer Vision to Extend Worksite Safety

The project aims to extend worksite safety of construction projects at Hydro-Quebec (HQ) using computer vision and a Real-Time Location System (RTLS). The case study is a substation construction project near Montreal. The main safety risks that will be targeted in the case study are related to equipment mobility (struck-by accidents) and not wearing Personal […]

Read More
Erosion studies of southern Ontario tills and St. Lawrence Valley marine clays and assessment of an extreme precipitation prediction approach

Quaternary glacial deposition has covered much of southern Ontario with tills and the Saint Lawrence Valley with marine fines. Rivers incised into these materials exhibit particular geomorphologic behavior. Civil engineering works built either in (e.g. dams, bridge piers, etc.), beside (linear infrastructure such as roads, railways, etc.) or across (e.g. bridges, etc.) such rivers must […]

Read More
Innovative Sustained High Strength Silicate Based Shotcretes

Due to early strength requirements, shotcrete mix must incorporate rapid set accelerating agents to speed up mix set time and accelerate hardening. Silicate-based shotcrete accelerators have demonstrated good early compressive strength, short set time and good stiffening properties at relatively low cost. The silicate-based shotcrete mix also has minimal impacts on health, environment and improved […]

Read More
Simulation-Enabled Intelligent Decision Support for Planning Precast Concrete Production Operations

Advances in engineering technology and requirements for sustainable development are main drivers for changes and innovations in the current construction industry. The paradigm shift to precast construction moves conventional field construction efforts into the controlled environment of an offsite manufacturing facility. These precast concrete products lend a significant advantage in execution of fast-paced construction projects, […]

Read More
Improved Lateral Supports for Fresh Masonry Structures at Construction Site

Despite significant development of various construction materials, masonry is still considered as one of the most cost-effective materials. However, they are often vulnerable to wind-induced lateral loads caused during construction stage (within 1 to 2 days of construction) when the masonry is yet to achieve full strength. Temporary bracing systems are often used to support […]

Read More
Connections Design in New Double Wythe Insulated Wall Panel Containing Ultra-High Performance Concrete (UHPC)

Ultra-high-performance concrete (UHPC) double wythe panels are commonly used in building envelopes, however, the connections between panels have not been investigated properly. Several design connections will be designed and tested in association with the industrial partner to determine the feasibility of the designs. The project will investigate the structural behaviour and strength of different connections […]

Read More
Use of Recycled concrete Aggregate to Produce Concrete Masonry Blocks

Concrete—the most common construction material in the world—represents the main component of construction and demolition waste. The excessive extraction of virgin aggregate from Canadian lands and water bodies destroys the habitats of many species and affects the natural flow of streams in lakes and rivers. One solution to address the growing solid waste challenge and […]

Read More
Experimental investigation of controlled-rocking systems

The proposed project will investigate the behavior of high-performance reinforced concrete (RC) core walls, which are designed to rock about their base in two horizontal directions. For this purpose, a 1/6.5 scaled specimen of the 24-story reinforced concrete wall will be built and tested at the Multi-Array Shaking Table (MAST) facility at Tongji University, Shanghai, […]

Read More
La reconversion de bâtiments inustriels – Étude comparative d’un cas montréalais et brummi

Le projet de recherche proposé s’intéresse aux éléments caractérisant la reconversion architecturale de bâtiments industriels à Montréal ainsi qu’à Birmingham. À cette fin, je réaliserai une étude de cas comparative me permettant de comparer le recyclage du Centre Phi à un cas brummi qu’il me faut encore sélectionner. Je me pencherai, d’une part, sur le […]

Read More
Urban storm sewer systems management and life-cycle costing

Urban stormwater infrastructures are the first line of defense from pluvial flooding and play a key role in protecting the environment. These systems are costly to construct and would be even more expensive to replace. Therefore, high priority must be given to maintaining the physical integrity of the assets and preserve the hydraulic capacity of […]

Read More